In this video we tried to show how to engrave photo on plywood with a CO2 laser machine. If this video was helpful and you want more, don’t forget to follow us and like our videos.

?Photo engraving on plywood

✔️You need to prepare a photo, for this we use the PhotoGraV program.
✔️You can also make similar results in any other photo editor such as Adobe Photoshope.
✔️In the program parameters, select the engraving on wood and the displayed result.
✔️Set the contrast parameters so that the displayed result meets your needs.
✔️Then import the resulting photo into RDworks.
✔️Set the engraving parameters, they depend on the power of your machine.
✔️In this example we are using a RECI W2 90W tube.
✔️Speed:, power:
✔️Adjust the air setting within 0.5-1 atmospheres.
✔️Adjust the focal length.
✔️Start the machine and observe the progress of the work.
✔️Please note that the material must be burned through no more than 0.1-0.2 mm.
✔️If the material burns through harder, turn down the power and increase the speed.
✔️The photo is ready!
————————————————–
To learn more how to choose a laser machine for your tasks or how to work with the other materials, please follow us.
If you need advice on laser or milling equipment, you can contact Wattsan.

❗For any questions please feel free to contact our customer support. It is there for you 24/7:
+8613153105797
[email protected]
————————————————–
? FOLLOW US
Facebook: https://www.facebook.com/cncwattsan
Instagram: https://www.instagram.com/wattsancnc
Pinterest: https://www.pinterest.com/wattsanlaser

source