This week our docket was full up with CNC plasma work for other fabricators and a sign for a local business. Finally getting the shop reopened and firing on all cylinders again.
For those interested in the coffee I mentioned today, please check out the website @ http://www.sludgecoffeeroaster.com
Sincerely,
Tom
source
This week our docket was full up with CNC plasma work for other fabricators and a sign for a local business. Finally getting the shop reopened and firing on all cylinders again. For those interested in the coffee I mentioned today, please check out the website @ http://www.sludgecoffeeroaster.com Sincerely, Tom source
December 11, 2022
After more than a year is my CNC milling machine finally alive. But there are plenty of problems to solve till perfect running.
Hope you will enjoy the video 🙂
If you like the video please share it with your friend to support my work or check mi Instagram or Facebook 🙂
source
After more than a year is my CNC milling machine finally alive. But there are plenty of problems to solve till perfect running. Hope you will enjoy the video 🙂 If you like the video please share it with your friend to support my work or check mi Instagram or Facebook 🙂 source
November 26, 2022
UPDATED DIY VERSION (I made better one): https://www.youtube.com/watch?v=D-22mZZNXHo
I am in the process of building a homemade CNC Plasma table. This table is designed to use a 4ft by 4ft work piece and utilizes LinuxCNC software with HobbyCNC electronics. Plasma cutter is an Everlast Powerplasma 60s with machine torch. This video goes over the frame and computer mounts and motion rails that I am using for the build. The next video will cover electronics! Very fun build! Link to the sliders I used for my build from ebay: https://www.ebay.com/itm/CNC-Router-Plasma-Gantry-Carriage-Rail-Car-NEMA-23-motor-2×2-2×3-or-2×4/123469747929?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Chapters:
0:00 Introduction
0:41 Parts Overview
2:51 Frame Start
5:19 Slat Holders Installation
6:15 Painting and Hardware
7:15 Final Touches
10:55 Final Overview
source
UPDATED DIY VERSION (I made better one): https://www.youtube.com/watch?v=D-22mZZNXHo I am in the process of building a homemade CNC Plasma table. This table is designed to use a 4ft by 4ft work piece and utilizes LinuxCNC software with HobbyCNC electronics. Plasma cutter is an Everlast Powerplasma 60s with machine torch. This video goes over the frame and computer mounts and motion
