My Pm940m-CNC Finally came in and I though I would do an un-crating video with some talk about about the mill.
You do have to email and ask for the PM-940M CNC version as all they list on their website is the non cnc version. They sell both a VFD and a Non-VFD version.
I got the non VFD version and it was $7,347.00 with freight shipping. I went with the non VFD version as I eventually plan to run this machine on LinuxCNC and didn’t want to have to spend more to get a compatible VFD if the one that would of come with the mill didn’t work.
Specs from Precision Mathews:
http://www.precisionmatthews.com/shop/pm-940m/
Main Specifications of PM-940M:
Table Size: 9-1/2″x40″
Max. Recommended Table Load Capacity: 400 lbs (Centered)
Table T-Slot Size and Number: 14mm / 9/16″, 3 Slots
Table Travel, X Axis: 28″ Hand Only, 26″ w/ Power Feed
Table Surface Height from floor, 35″ (With base flat on floor)
Base Dimension at floor approx. 18-1/2″W x 27″D, with 5/8″ Bottom Holes for leveling pads/bolts
Normal Working Max Height: (top of column travel motor) 82″ (with base)
Height with head all the way up: (top of main motor) 85″(with base)
Stand (Base) height, to machine mounting surface: 24″
Cross Travel, Y Axis: 12″
Head Vertical Travel: 20″
Max. Distance Spindle to Table: 22″
Quill (Spindle) Travel: 5″
Lead Screw Type: Inch Pitch Acme Threads – 10TPI on X and Y Axis
Spindle Taper: R-8, with 7/16-20 drawbar thread (U.S. Standard)
Quill Diameter: approx. 3″
Head Swivel: Side To Side, 90 Degrees
Power Required: 220 Volt, Single Phase, 10 Amp Supply
Main Motor Horsepower: 2 H.P.
Casting Type: Fine Grain Cast Iron
Approximate Weight: 1350lbs with Base
If you want to see the un-crating only:
source
